Re: [PATCH] branch.autosetupmerge: allow boolean values, or "all"

From: Johannes Schindelin <johannes.schindelin@gmx.de>
Date: Jul 9, 2007, 11:28 UTC
Message-ID: <Pine.LNX.4.64.0707091025250.4248@racer.site>
In-Reply-To: <46919692.5020708@gnu.org>

Hi,

On Sun, 8 Jul 2007, Paolo Bonzini wrote:

Show 9 quoted lines

> [Paolo tried to hide the fact that it was Junio who wrote this:]
>
> > Having prepared the patch below, I do not think if the original patch 
> > even wanted to have 'all' semantics.  The surrounding text only talks 
> > about "off a remote branch" and I strongly suspect that nobody wanted 
> > to do this for a local branch case at all.
> 
> If I remember correctly, the problem was that you are not sure that 
> remote branches are in refs/remotes.

Then you code is incorrect.

Basically, you use a confusing set of four functions to do the following:

- read the config, and
- write the branch.<name>.{remote,merge} variables

Two functions would have been sufficient, and easier to read. And as I fully expect with non-simple code, a bug was lurking. This time in set_branch_defaults():

you check if neither config_repo nor config_remote (which is a misnomer, as it does not contain a "remote", but a "remote branch") is set. But that happens when there was no information in the config, too!

Also you miss the case that there is ambiguous information:

[remote "hello"]
	url = git://blub/x.git
	fetch = refs/heads/master:refs/heads/origin

[remote "bello"]
	url = git://yaddayadda/x.git
	fetch = refs/heads/master:refs/heads/origin

See? Your code just uses "bello".

Will send out a fix shortly.

Ciao, Dscho