Re: [PATCH 0/5] Skip 'cache_tree_update()' when 'prime_cache_tree()' is called immediate after

> Derrick Stolee wrote:
>> On 11/8/2022 5:44 PM, Victoria Dye via GitGitGadget wrote:
>>> Following up on a discussion [1] around cache tree refreshes in 'git reset',
>>> this series updates callers of 'unpack_trees()' to skip its internal
>>> invocation of 'cache_tree_update()' when 'prime_cache_tree()' is called
>>> immediately after 'unpack_trees()'. 'cache_tree_update()' can be an
>>> expensive operation, and it is redundant when 'prime_cache_tree()' clears
>>> and rebuilds the cache tree from scratch immediately after.
>>>
>>> The first patch adds a test directly comparing the execution time of
>>> 'prime_cache_tree()' with that of 'cache_tree_update()'. The results show
>>> that on a fully-valid cache tree, they perform the same, but on a
>>> fully-invalid cache tree, 'prime_cache_tree()' is multiple times faster
>>> (although both are so fast that the total execution time of 100 invocations
>>> is needed to compare the results in the default perf repo).
>>
>> One thing I found interesting is how you needed 200 iterations to show
>> a meaningful change in this test script, but in the case of 'git reset'
>> we can see sizeable improvements even with a single iteration.
> 
> All of the new performance tests run with multiple iterations: 20 for reset
> (10 iterations of two resets each), 100 for read-tree, 200 for the
> comparison of 'cache_tree_update()' & 'prime_cache_tree()'. Those counts
> were picked mostly by trial-and-error, to strike a balance of "the test
> doesn't take too long to run" and "the change in execution time is clearly
> visible in the results."

>> Is there something about this test that is artificially speeding up
>> these iterations? Perhaps the index has up-to-date filesystem information
>> that allows these methods to avoid filesystem interactions that are
>> necessary in the 'git reset' case?
> 
> I would expect the "cache_tree_update, invalid" test's execution time, when
> scaled to the iterations of 'read-tree' and 'reset', to match the change in
> timing of those commands, but the command tests are reporting *much* larger
> improvements (e.g., I'd expect a 0.27s improvement in 'git read-tree', but
> the results are *consistently* >=0.9s).
> 
> Per trace2 logs, a single invocation of 'read-tree' matching the one added
> in 'p0006' spent 0.010108s in 'cache_tree_update()'. Over 100 iterations,
> the total time would be ~1.01s, which lines up with the 'p0006' test
> results. However, the trace2 results for "test-tool cache-tree --count 3
> --fresh --update" show the first iteration taking 0.013060s (looks good),
> then the next taking 0.003755s, then 0.004026s (_much_ faster than
> expected).
> 
> To be honest, I can't figure out what's going on there. It might be some
> kind of runtime/memory optimization with repeatedly rebuilding the same
> cache tree (doesn't seem to be compiler optimization, since the speedup
> still happens with '-O0'). The only sure-fire way to avoid it seems to be
> moving the iteration outside of 'test-cache-tree.c' and into 'p0090'.
> Unfortunately, the command initialization overhead *really* slows things
> down, but I can add a "control" test (with no cache tree refresh) to
> quantify how long that initialization takes.