Re: [PATCH 2/2] Unset CURLOPT_FAILONERROR

>
> On Fri, Dec 28, 2018 at 2:51 PM Masaya Suzuki <masayasuzuki@google.com> wrote:
> > On Fri, Dec 28, 2018 at 11:37 AM Eric Sunshine <sunshine@sunshineco.com> wrote:
> > > On Thu, Dec 27, 2018 at 8:47 PM Masaya Suzuki <masayasuzuki@google.com> wrote:
> > > > +test_expect_success 'failure in git-upload-pack is shown' '
> > > > +       (GIT_CURL_VERBOSE=1 git clone --bare "$HTTPD_URL/error_git_upload_pack/smart/repo.git" 2>curl_log ||
> > > > +        true) &&
> > >
> > > Using test_might_fail() would allow you to drop the subshell and the "|| true":
> > >
> > >     test_might_fail env GIT_CURL_VERBOSE=1  git clone ... &&
> > >
> > > > +       cat curl_log | grep "< HTTP/1.1 500 Intentional Breakage"
> > > > +'
> >
> > The test should success. This is a test that a log is produced after a
> > git command fails. The point of this test is "cat curl_log | grep ..."
> > part that asserts the log.
>
> Unfortunately, the name "test_might_fail" is confusing. It is not
> saying that the entire test might or might not fail. Rather, it is
> saying that the one command might or might not fail (and that you
> don't care if it does fail). The idiom:
>
>     (some-git-command || true) &&
>
> can be replaced with:
>
>    test_might_fail some-git-command &&
>
> without changing its meaning, and without affecting the
> success/failure status of the test overall.
>
> So, this new test could be written like this:
>
> --- 8< ---
> test_expect_success 'failure in git-upload-pack is shown' '
>    test_might_fail env GIT_CURL_VERBOSE=1 git clone --bare
> "$HTTPD_URL/error_git_upload_pack/smart/repo.git" 2>curl_log &&
>    cat curl_log | grep "< HTTP/1.1 500 Intentional Breakage"
> '
> --- 8< ---
>
> and have the same meaning.