Re: [PATCH] pathspec: adjust prefixlen after striping trailing slash

> Duy Nguyen <pclouds@gmail.com> writes:
>
>> On Mon, Apr 20, 2015 at 12:37 PM, Junio C Hamano <gitster@pobox.com> wrote:
>>> Duy Nguyen <pclouds@gmail.com> writes:
>>>
>>>> But if you look at it another way, "cd subrepo; git add ." should be
>>>> the same as "git add subrepo" ...
>>>
>>> Once you cd into "subrepo", you are in a different world, a world
>>> different from the toplevel project.  "git add ." over there should
>>> mean "add everything in subproject's working tree to subproject's
>>> index", shouldn't it?  On the other hand, "git add subrepo" without
>>> leavingin the working tree of the superproject is about binding the
>>> submodule to the superproject's index.
>>>
>>> I do not think these two should be the same.  Where am I mistaken?
>
>> I think I wrote this sentence and deleted it: I didn't say which way
>> was right.
>
> OK.
>
> I looked at the test script update.  The new test does (I am
> rephrasing to make it clearer):
>
>      mkdir -p dir/ectory
>      git init dir/ectory ;# a new directory inside top-level project
>      (
>          cd dir/ectory &&
>          >test && git add test && git commit -m test
>      )
>      git add dir/ectory
>
> to set it up.  At this point, the top-level index knows dir/ectory
> is a submodule.
>
> Then the test goes on to turn it a non submodule by
>
>      mv dir/ectory/.git dir/ectory/dotgit
>
> At this point, I think there are two valid things that can happen.
>
>   (1) "git add test" inside dir/ectory removes the submodule entry
>       "dir/ectory" and then adds dir/ectory/test as an individual
>       entry.  After all that is what happens when you replace a file
>       with a directory, e.g.
>
>         >folder && git add folder
>         rm folder
>         mkdir folder && >folder/file &&
>         git -C folder add file
>
>       will first register a regular file "folder" and then replace
>       that with paths underneath.
>
>       It would be the same if you did any of the following:
>
>         git -C . add dir/ectory/test
>         git -C dir add ectory/test
>         git -C dir/ectory add test
>
>   (2) "git add test" inside "dir/ectory" would barf, saying
>       "dir/ectory is supposed to be a submodule and you have to first
>       remove it".  Again, it would be the same if you did so from any
>       directory with relative paths.
>
> I think (2) is less optimal than (1), but it could be the best we
> could do if the submodule infrastracture around .gitmodules and
> links to $GIT_DIR/modules/$name may have to get involved in an
> operation like this (I didn't check).