Re: GIT on MinGW problem

From: Marius Storm-Olsen <marius@trolltech.com>
Date: May 29, 2007, 14:36 UTC
Message-ID: <465C3A88.3090606@trolltech.com>
In-Reply-To: <465C2999.677860A6@eudaptics.com>

Johannes Sixt said the following on 29.05.2007 15:24:

Show 11 quoted lines

>> Looking at the docs for cmd's call (run 'help call'), I see now that
>> it can be written
>>      %~dp0gitk
>> as well..
> 
> But... the docs also say that this stuff is only available if command
> extensions are turned on. Are they on by default?
> 
> (I cannot tell because I remember faintly that I fiddled with the
> corresponding registry setting in the past, but don't know whether it
> was on or off at the beginning.)

Ok, MSDN says it on by default on XP, while other docs say its on by default without specifying any platforms. Also, it might be that the %~dp0 construct is only supported on later versions of the cmd extension too (I don't have NT 4, so I can't test this), so to be on the safe side you can do this:

---- @echo off REM This GOTO relies on the hack that command.com only supports REM 8 character labels, so it reads 'goto _Windows' goto :_WindowsNT

REM Command.com jumps here :_Windows wish84.exe "C:\Git\usr\bin\gitk" %1 %2 %3 %4 %5 %6 %7 %8 %9 REM NOTE! If you install Git in some other path, and use REM command.com, you need to replace the path above

goto :EOF

REM Cmd.exe jumps here
:_WindowsNT
if "%1" neq "ensureExt" (
    REM Call the script again with cmd /X to explicitly turn on Command Extensions
    %COMSPEC% /X /C "%0 ensureExt %*"
    goto :EOF
)

REM If our CMD Extension version is less than 2, we might not support the %~dp0
REM construct so, just do the normal _Windows call instead. (This should only
REM happen on old Windows NT 4, where the extension is not so sophisticated
if not cmdextversion 2 (
    call :_Windows %2 %3 %4 %5 %6 %7 %8 %9
    goto :EOF
)
start wish84.exe "%~dp0gitk" %2 %3 %4 %5 %6 %7 %8 %9

:EOF

-- 
.marius