Re: pull is not a git command - 1.7.6.4
- From
- Eugene Sajine <euguess@gmail.com>
- Date
- Oct 25, 2011, 18:10 UTC
- Message-ID
- <CAPZPVFZKNdDcnaVn237gArqdBuc4ek77vxsp8BMaicARBTKqBg@mail.gmail.com>
- In-Reply-To
- <vpqr521j98h.fsf@bauges.imag.fr>
On Tue, Oct 25, 2011 at 1:01 PM, Matthieu Moy <Matthieu.Moy@grenoble-inp.fr> wrote:
Show 29 quoted lines
> Eugene Sajine <euguess@gmail.com> writes: > >> On Tue, Oct 25, 2011 at 12:45 PM, Junio C Hamano <gitster@pobox.com> wrote: >> >>> Just a wild guess. perhaps you specified prefix=/usr/local/git-1.7.4.1/ >>> eons ago when you built and installed 1.7.4.1 like this: >>> >>> make prefix=/usr/local/git-1.7.4.1 all install >>> >>> and then you did it differently when you installed 1.7.6.4, e.g. >>> >>> make all >>> make prefix=/usr/local/git-1.7.6.4 install >>> >>> >> >> >> Are you saying that the first command is more correct? >> I will check it. > > At build time, Git registers the "exec path" (i.e. where to find > git-<command> executables). So, if you run "make all" without specifying > the install path, Git will set an arbitrary exec-path, and the > installation won't work. > > -- > Matthieu Moy > http://www-verimag.imag.fr/~moy/ >
Matthieu/Junio,
Thank you very much for your help - there was a mistake made during the build where the exec path folder was incorrect and unreachable.
Thanks!