Re: The error subcommand given by git tab completion.
- From
胡哲宁 <adlternative@gmail.com>
- Date
- Feb 1, 2021, 16:18 UTC
- Message-ID
- <CAOLTT8RVL15NUVJHz657yeAycuUeOR6i4Z6TGehLPRjrUxmoTw@mail.gmail.com>
- In-Reply-To
- <CAGP6POLQ_6cZHh0UCaavNBL7+FcMEX8bwb=VxvNMtmO0ZSCPwg@mail.gmail.com>
git gui works normally for me in arch. You should go to install some dependent commands.
Hongyi Zhao <hongyi.zhao@gmail.com> 于2021年2月1日周一 下午11:19写道:
Show 48 quoted lines
> > On Ubuntu 20.04, the `git TAB' will give me the following available subcommands: > > $ git TAB > add deborig merge rm > am describe mergetool send-email > apply diff mv shortlog > archive difftool notes show > bisect fetch pull show-branch > blame format-patch push sparse-checkout > branch fsck range-diff stage > bundle gc rebase stash > checkout gitk reflog status > cherry grep remote submodule > cherry-pick gui repack switch > citool help replace tag > clean init request-pull whatchanged > clone instaweb reset worktree > commit latexdiff restore > config log revert > > Then I try the following: > > $ git gui > git: 'gui' is not a git command. See 'git --help'. > > The most similar commands are > gc > grep > init > pull > push > > The git version is shown as below: > > $ git --version > git version 2.25.1 > > As you can see, gui is among the auto-completed subcommands list, but > it can be run like the manner of other subcommands. Any hints for this > problem? > > Regards > -- > Assoc. Prof. Hongyi Zhao <hongyi.zhao@gmail.com> > Theory and Simulation of Materials > Hebei Polytechnic University of Science and Technology engineering > NO. 552 North Gangtie Road, Xingtai, China