How to see raw output from 'make test'?

Hi Everyone,

I built Git 2.2.0 from sources. I added CFLAGS="-DNDEBUG -g2 -O1 -fsantize=undefined'. Then, a 'make test V=1'. The tests don't produce output. For example:

*** t0021-conversion.sh *** ok 1 - setup ok 2 - check ok 3 - expanded_in_repo ok 4 - filter shell-escaped filenames ok 5 - required filter should filter data ok 6 - required filter smudge failure ok 7 - required filter clean failure ok 8 - filtering large input to small output should use little memory ok 9 - filter that does not read is fine

Yet when I grep for 'runtime error' I am getting some hits for undefined behavior:

git-2.21.0$ grep -IR 'runtime error' t/trash directory.t0021-conversion/err:sha1dc/sha1.c:392:2: runtime error: load of misaligned address 0x000002d7d1d5 for type 'const uint32_t', which requires 4 byte alignment t/trash directory.t0021-conversion/err:sha1dc/sha1.c:397:2: runtime error: load of misaligned address 0x000002d7d1d5 for type 'const uint32_t', which requires 4 byte alignment t/trash directory.t0021-conversion/err:sha1dc/sha1.c:402:2: runtime error: load of misaligned address 0x000002d7d1d5 for type 'const uint32_t', which requires 4 byte alignment t/trash directory.t0021-conversion/err:sha1dc/sha1.c:407:2: runtime error: load of misaligned address 0x000002d7d1d5 for type 'const uint32_t', which requires 4 byte alignment ...

How do I get the full output from 'make test'?

Thanks in advance.