Re: sudmodule.<name>.recurse ignored

> THE CONFIGURATION OF SUBMODULES
>        Submodule operations can be configured using the following mechanisms (from highest to lowest precedence):
>
>        •   The command line for those commands that support taking submodules as part of their pathspecs. Most commands have a boolean
>            flag --recurse-submodules which specify whether to recurse into submodules. Examples are grep and checkout. Some commands
>            take enums, such as fetch and push, where you can specify how submodules are affected.
>
>        •   The configuration inside the submodule. This includes $GIT_DIR/config in the submodule, but also settings in the tree such
>            as a .gitattributes or .gitignore files that specify behavior of commands inside the submodule.
>
>            For example an effect from the submodule’s .gitignore file would be observed when you run git status
>            --ignore-submodules=none in the superproject. This collects information from the submodule’s working directory by running
>            status in the submodule while paying attention to the .gitignore file of the submodule.
>
>            The submodule’s $GIT_DIR/config file would come into play when running git push --recurse-submodules=check in the
>            superproject, as this would check if the submodule has any changes not published to any remote. The remotes are configured
>            in the submodule as usual in the $GIT_DIR/config file.
>
>        •   The configuration file $GIT_DIR/config in the superproject. Git only recurses into active submodules (see "ACTIVE
>            SUBMODULES" section below).
>
>            If the submodule is not yet initialized, then the configuration inside the submodule does not exist yet, so where to obtain
>            the submodule from is configured here for example.
>
>        •   The .gitmodules file inside the superproject. A project usually uses this file to suggest defaults for the upstream
>            collection of repositories for the mapping that is required between a submodule’s name and its path.
>
>            This file mainly serves as the mapping between the name and path of submodules in the superproject, such that the
>            submodule’s Git directory can be located.
>
>            If the submodule has never been initialized, this is the only place where submodule configuration is found. It serves as
>            the last fallback to specify where to obtain the submodule from.
>
>
> However, when we are talking about the recurse attribute, it is
> not taken from .gitmodules - only command line and .git/config seem
> to be consulted.
> Is this a bug or a feature?