Re: P4 Sync problem

Hi, I know this is an old thread, but I think it might be relevant. (At any rate, at least you know I've been looking).

I'm trying to use git-p4 with a very large P4 repository, of which my client view is a small fraction. My client view is within the administrator-set file limit of P4 files. E.G., p4 sync //depot/... works.

When I call git-p4 sync or clone, however, it bumps into the limit. Even if I am using client spec and detecting branches. If p4 were successfully detecting my branches -or- using my client spec, I would not be running into the limit. But:

git p4 sync //depot@all --use-client-spec --detect-branches --verbose
Syncing with origin first by calling git fetch origin
executing git fetch origin
Reading pipe: git config git-p4.user
Reading pipe: git config git-p4.password
Reading pipe: git config git-p4.port
Reading pipe: git config git-p4.host
Reading pipe: git config git-p4.client
p4 -u mkramer -c mkramer -G client -o
Opening pipe: p4 -u mkramer -c mkramer -G client -o
Reading pipe: git rev-parse --symbolic  --remotes
Reading pipe: git rev-parse p4/master
p4-git branches: []
initial parents: {}
Getting p4 changes for //depot/...
p4 -u mkramer -c mkramer changes //depot/...
Reading pipe: p4 -u mkramer -c mkramer changes //depot/...
Request too large (over 110000); see 'p4 help maxresults'.
Traceback (most recent call last):
  File "/home/mkramer/git/bin/git-p4", line 1924, in <module>
    main()
  File "/home/mkramer/git/bin/git-p4", line 1919, in main
    if not cmd.run(args):
  File "/home/mkramer/git/bin/git-p4", line 1671, in run
    changes = p4ChangesForPaths(self.depotPaths, self.changeRange)
  File "/home/mkramer/git/bin/git-p4", line 444, in p4ChangesForPaths
    for p in depotPaths]))
  File "/home/mkramer/git/bin/git-p4", line 108, in p4_read_pipe_lines
    return read_pipe_lines(real_cmd)
  File "/home/mkramer/git/bin/git-p4", line 101, in read_pipe_lines
    die('Command failed: %s' % c)
  File "/home/mkramer/git/bin/git-p4", line 59, in die
    raise Exception(msg)
Exception: Command failed: p4 -u mkramer -c mkramer changes //depot/...

Is this a limitation in the current --use-client-spec or --detect-branches flags, or am I doing it wrong?