Re: git-receive-pack --stateless-rpc
On Thu, Jun 17, 2010 at 6:45 AM, Yiyi Sun <yiyisun@gmail.com> wrote:
Show 13 quoted lines
> I am creating a Git smart HTTP protocol wrapper and run into two
> problem. I tried the msysGit mailing list and was told to ask them to
> the main git mailing list.
>
> Here is the story. During 'git push', I successfully processed the
> initial GET request of '/info/refs?service=git-receive-pack' by
> sending back the output of 'git receive-pack --stateless-rpc
> --advertise-refs'. Then msysGit did a the POST request. I
> invoked 'git receive-pack --stateless-rpc', which returned:
>
> 0030 000eunpack ok
> 0019ok refs/heads/master
> 00000000
That doesn't look right to me. There appears to be a space at the start of the packet (between 0030 and 000e), which would confuse the protocol. Otherwise, that appears to be a valid response from receive-pack assuming the client asked for side-band-64k in the request, and it pushed only refs/heads/master.
Show 5 quoted lines
> Question #1, Is the result supposed to be something below instead?
>
> 000eunpack ok
> 0019ok refs/heads/master
> 0000
Depends on whether or not the client asked for side-band-64k. If it did, we wrap it up in a another pkt-line framing like above, and end with another flush-pkt. If the client didn't ask for side-band-64k, then the above would be the correct response.
Show 5 quoted lines
> Question #2, msysGit cannot parse the result, it displays error message:
>
> fatal: protocol error: bad line length character:
> 003
> fatal: The remote end hung up unexpectedly
This is weird. "003" isn't valid, its not 4 bytes long. What was that trailing final 4th byte right there? If its a space like it is above (though then its really in the wrong spot, isn't it?) that would throw it all off.
It sounds to me like your wrapper is mangling the data that is passing through it on the way back to the client.
--
Shawn.
