Re: Real-life kernel debugging scenario
On Mon, 7 Nov 2005, walt wrote:
Show 13 quoted lines
>
> Okay. On rare occasions I get a kernel panic on reboot. So...
> I know that something Linus committed in the last 24 hours is
> responsible for the problem.
>
> The last two times this happened I was able to guess which
> commit caused the problem and I emailed the developer off-
> list and got the problem fixed very quickly. (This is why
> I love open-source software!)
>
> My worry: what happens when I'm not smart enough to guess
> which developer to email? My first instinct is to back out
> the most recent commits one-by-one until the bug goes away.
No. This is what "git bisect" is there for.
It works wonderfully well. To the point where I don't even try to be smart about things: I've had two cases in the last month of merges that caused problems for me, and instead of even trying to guess which patch it was, I just bisected it.
Show 6 quoted lines
> First: is this an optimal tactic?
>
> Second: how to back out individual commits using git or
> cogito? I suppose this is already spelled out in the docs,
> but I invite everyone to point me to the relevant places
> in the docs that have escaped my attention so far.
First, try "git bisect". It doesn't depend on backing out individual commits, instead it starts a special "bisect" branch, and (as the name implies) does a binary search within that branch to figure out what is wrong.
The way to use "git bisect" couldn't be easier.
Figure out what the oldest bad state you know about is (that's usually the head of "master", since that's what you just tried to boot and failed at). Also, figure out the most recent known-good commit (usually the _previous_ kernel you ran: and if you've only done a single "pull" in between, it will be ORIG_HEAD).
Then do
git bisect start
git bisect bad master <- mark "master" as the bad state
git bisect good ORIG_HEAD <- mark ORIG_HEAD as good (or
whatever other known-good
thing you booted laste)
and at this point "git bisect" will churn for a while, and tell you what the mid-point between those two commits are, and check that state out as the head of the bew "bisect" branch.
Compile and reboot.
If it's good, just do
git bisect good <- mark current head as good
otherwise, reboot into a good kernel instead, and do (surprise surprise, git really is very intuitive):
git bisect bad <- mark current head as bad
and whatever you do, git will select a new half-way point. Do this for a while, until git tells you exactly which commit was the first bad commit. That's your culprit.
It really works wonderfully well, except for the case where there was _another_ commit that broke something in between, like introduced some stupid compile error. In that case you should not mark that commit good or bad: you should try to find another commit close-by, and do a "git reset --hard <newcommit>" to try out _that_ commit instead, and then test that instead (and mark it good or bad).
You can do "git bisect visualize" while you do all this to see what's going on by starting up gitk on the bisection range.
Finally, once you've figured out exactly which commit was bad, you can then go back to the master branch, and try reverting just that commit:
git checkout master
git revert <bad-commit-id>
to verify that the top-of-kernel works with that single commit reverted.
Linus
