when fast forwarding.
Note that in the first hunk of this patch, there was this line:
test "a$1" = a-n && output git reset --soft $current_sha1
but the test always failed.
Signed-off-by: Christian Couder <chriscool@tuxfamily.org>
---
The test "a$1" = a-n fails because if "$1" is set to "-n"
then "$no_ff" is set to "t" above by:
case "$1" in -n) sha1=$2; no_ff=t ;; *) sha1=$1 ;; esac
and that means that:
test "$no_ff$current_sha1" = "$parent_sha1"
will fail.
But maybe I missed something. Otherwise I can send a patch
for master to remove the dead code.
git-rebase--interactive.sh | 11 +++--------
1 files changed, 3 insertions(+), 8 deletions(-)
Show changes to git-rebase--interactive.sh +3 −8
diff --git a/git-rebase--interactive.sh b/git-rebase--interactive.sh
index 0041994..7651fd6 100755
--- a/git-rebase--interactive.sh
+++ b/git-rebase--interactive.sh
@@ -154,11 +154,8 @@ pick_one () {
die "Could not get the parent of $sha1"
current_sha1=$(git rev-parse --verify HEAD)
if test "$no_ff$current_sha1" = "$parent_sha1"; then
- git sequencer--helper --reset-hard $sha1 \
+ git sequencer--helper --fast-forward $sha1 \
"$GIT_REFLOG_ACTION" "$VERBOSE"
- test "a$1" = a-n && output git reset --soft $current_sha1
- sha1=$(git rev-parse --short $sha1)
- output warn Fast forward to $sha1
else
output git cherry-pick "$@"
fi
@@ -238,10 +235,8 @@ pick_one_preserving_merges () {
done
case $fast_forward in
t)
- output warn "Fast forward to $sha1"
- git sequencer--helper --reset-hard $sha1 \
- "$GIT_REFLOG_ACTION" "$VERBOSE" ||
- die "Cannot fast forward to $sha1"
+ git sequencer--helper --fast-forward $sha1 \
+ "$GIT_REFLOG_ACTION" "$VERBOSE" || exit
;;
f)
first_parent=$(expr "$new_parents" : ' \([^ ]*\)')
--
1.6.4.209.g16b77
Christian Couder