From: Junio C Hamano Date: Thu, 09 Apr 2026 21:09:42 GMT Subject: Re: [PATCH] wrapper: properly handle MAX_IO_SIZE in `write_in_full()` Message-ID: In-Reply-To: <20260409205928.GD3076846@coredump.intra.peff.net> Jeff King writes: > On Thu, Apr 09, 2026 at 01:40:36PM -0700, Junio C Hamano wrote: > >> >> As the width of ssize_t in bits can be a lot smaller than size_t, >> >> the above "unsigned_add_overflows() triggers way too late for the >> >> check to matter, no? >> > >> > I think it is correct as-is. >> > >> > The real check against ssize_t is later, when we compare total_length to >> > MAX_IO_SIZE (which is clamped to SSIZE_MAX). So this is just making sure >> > we do not overflow size_t when counting up the total (and if we do, we >> > _know_ we are going to overflow ssize_t, which must be smaller). >> >> But then what happens after it breaks out of the loop? We cannot be >> at i==0, so let's say we have a reasonably small iov[0] and iov[1] >> that is so large and makes size_t wraparound. We break out here, >> and then send the iov[0] with writev(). But have we checked if >> iov[0] is under MAX_IO_SIZE in that case before calling writev()? > > I think so. Either: > > - We completed the first iteration of the loop successfully (and i >= > 1), in which case we added iov[0].iov_len to total_length, and then > compared total_length against MAX_IO_SIZE, but did not break out of > the loop. So we know iov[0] is within the limits. > > - We bailed at i==0 either because of addition overflow, or because of > the MAX_IO_SIZE check. Either way, we will bail to xwrite() because > i is 0. Yup, you're right. There is no addition overflow at i==0, but I do not think we can construct a case where the sum is not checked against MAX_IO_SIZE before the vector is passed to underlying writev(). iov[0].iov_len that is slightly smaller than MAX_IO_SIZE would allow us to keep looping to i==1 at which time iov[1].iov_len is so big that we may trigger unsigned_add_overflows() check, but then what we send to writev() is the first segment, which is smaller than MAX_IO_SIZE, so we are OK. iov[0].iov_len that is slightly larger than MAX_IO_SIZE would stop us moving to i==1 at the end of the loop, and directly punt to xwrite(), so we are OK, too.