From: Eric Sunshine <sunshine@sunshineco.com>
Date: Mon, 16 Nov 2015 21:14:06 GMT
Subject: Re: [PATCH v5 3/6] git-p4: retry kill/cleanup operations in tests with timeout
Message-ID: <CAPig+cQkNB3VzbC_R_T=ppkgvmTbOWnK22hFxyMzJH1DZ_iVhQ@mail.gmail.com>
In-Reply-To: <1447592920-89228-4-git-send-email-larsxschneider@gmail.com>

On Sun, Nov 15, 2015 at 8:08 AM,  <larsxschneider@gmail.com> wrote:
> From: Lars Schneider <larsxschneider@gmail.com>
>
> In rare cases kill/cleanup operations in tests fail. Retry these
> operations with a timeout to make the test less flaky.
>
> Signed-off-by: Lars Schneider <larsxschneider@gmail.com>
> ---
> diff --git a/t/lib-git-p4.sh b/t/lib-git-p4.sh
> @@ -121,22 +125,33 @@ p4_add_user() {
>         EOF
>  }
>
> +retry_until_success() {
> +    timeout=$(($(date +%s) + $RETRY_TIMEOUT))

There was some discussion previously[1] about detecting dynamically
whether 'date +%s' was supported. Was this something that you intended
to do, or did you decide against it since p4 is not supported on such
platforms?

Same question also applies to patch 4/6.

[1]: http://article.gmane.org/gmane.comp.version-control.git/280978/match=lazy+prerequisite

> +    until "$@" 2>/dev/null || test $(date +%s) -gt $timeout
> +    do :
> +    done
> +}
> +
> +retry_until_fail() {
> +    timeout=$(($(date +%s) + $RETRY_TIMEOUT))
> +    until ! "$@" 2>/dev/null || test $(date +%s) -gt $timeout
> +    do :
> +    done
> +}