From: Michael Horowitz Date: Fri, 15 Apr 2011 20:39:54 GMT Subject: Re: git-p4 issue Message-ID: In-Reply-To: I am sure that is a common mistake people make, but not in this case. I have been using it successfully for a while now, it just suddenly stopped working, not sure what changed. I am not seeing anything on remotes/p4/master either, and I was originally doing rebase and went back to sync so I could run "--verbose" and see if it was even downloading those changes. I can clearly see it says it is downloading them, but then they just don't end up in git. Since I don't see an error message about it failing to sync, I am at a loss to figure out why it says it succeeded, but it didn't. Could there be one step in the code that is not catching an error condition? I am not all that familiar with Python, but if someone could point me where to put some debug messages, I can do some testing. Thanks, Mike On Fri, Apr 15, 2011 at 4:22 PM, Tor Arvid Lund wrote: > > On Fri, Apr 15, 2011 at 5:00 AM, Michael Horowitz > wrote: > > Pete, > > > > I was hoping you could help me out again.  After using git-p4 for a > > while without a problem, it has suddenly stopped working for me.  I am > > using the latest master.  I haven't seen any recent changes that I > > think could have caused this, but maybe you'll have some insight. > > > > The issue is that when I do a git-p4 sync on my existing repository, > > it reports success, but seems to do nothing.  It does not download the > > latest changes from p4.  If I delete my repository and start over, it > > will download all the latest changes, even the ones it was not > > downloading previously, but if I try to sync again later, it does not > > do anything.  I tried running it with the "--verbose" mode, and I see > > it says it is loading each of the changes, but they are not ending up > > in the git repository, and it is not reporting any errors. > > Hi, Michael. > > Is it possible that you expect that 'git p4 sync' should update your > working branch and/or working tree? Assuming a simple clone with a > local master branch, running 'git-p4 sync' will update the branch > remotes/p4/master, but it won't do anything on my working master > branch... > > Maybe you want to call 'git rebase p4/master' afterwards, or use the > shorthand 'git p4 rebase' to do a sync+rebase. > > Regards, > Tor Arvid. > > > Any ideas of what this could be?  Is there anything else I can run to > > help debug this? > > > > Thanks, > > > > Mike > > -- > > To unsubscribe from this list: send the line "unsubscribe git" in > > the body of a message to majordomo@vger.kernel.org > > More majordomo info at  http://vger.kernel.org/majordomo-info.html > >