From: Junio C Hamano <gitster@pobox.com>
Date: Thu, 05 Mar 2009 00:41:44 GMT
Subject: Re: [PATCH 2/2] better introduction of GIT with USE_NSEC defined
Message-ID: <7vk5744x87.fsf@gitster.siamese.dyndns.org>
In-Reply-To: <6d937a859ca499f534eea08720fca84f3d4ded2f.1236187259.git.barvik@broadpark.no>

Kjetil Barvik <barvik@broadpark.no> writes:

> Change the source code such that when USE_NSEC is not defined,
> possible nanosecond timestamps will still be saved in the index file,
> but not used inside if-test's, and will therefore not affect the
> outcome of GIT commands, other than the saved nanosecond timestamps in
> the index file.
>
> This will make it easier to use a system with 2 versions of GIT, one
> with and one without USE_NSEC defined.

I take it that you are responding to my earlier question with this patch?

    From: Junio C Hamano <gitster@pobox.com>
    Subject: Re: [PATCH/RFC v2 2/3] make USE_NSEC work as expected
    Date: Fri, 20 Feb 2009 00:35:35 -0800
    Message-ID: <7vab8hfqug.fsf@gitster.siamese.dyndns.org>

    Kjetil Barvik <barvik@broadpark.no> writes:

    > diff --git a/read-cache.c b/read-cache.c
    > index 940ec76..ca4bec2 100644
    > --- a/read-cache.c
    > +++ b/read-cache.c
    > @@ -67,8 +67,15 @@ void rename_index_entry_at(struct index_state *istate,..
    >   */
    >  void fill_stat_cache_info(struct cache_entry *ce, struct stat *st)
    >  {
    > -	ce->ce_ctime = st->st_ctime;
    > -	ce->ce_mtime = st->st_mtime;
    > +	ce->ce_ctime.sec = (unsigned int)st->st_ctime;
    > +	ce->ce_mtime.sec = (unsigned int)st->st_mtime;
    > +#ifdef USE_NSEC
    > +	ce->ce_ctime.nsec = (unsigned int)st->st_ctim.tv_nsec;
    > +	ce->ce_mtime.nsec = (unsigned int)st->st_mtim.tv_nsec;
    > +#else
    > +	ce->ce_ctime.nsec = 0;
    > +	ce->ce_mtime.nsec = 0;
    > +#endif

    How does this affect a use case where the same index file used with two 
    instances of git (one compiled with and another without USE_NSEC)?