From: David Frech Date: Wed, 11 Jul 2007 21:57:00 GMT Subject: Re: test suite fails if sh != bash || tar != GNU tar Message-ID: <7154c5c60707111457o424cd1a3g192cecc2e00936a8@mail.gmail.com> In-Reply-To: <7v7ip639cb.fsf@assigned-by-dhcp.cox.net> On 7/11/07, Junio C Hamano wrote: > "David Frech" writes: > > > One issue is that my server is on dynamic IP, and my lame ISP (the > > local telco) doesn't give me a proper SMTP relay - they want us to > > send our mail via HTTP to MSN! Completely lame. > > > > So sending mail can be an issue, if the receiver blocks mail from dynamic IPs. > > I think I heard gmail has incoming SMTP for its subscribers, and > I would not be surprised if other free e-mail providers have the > same. Perhaps you can use one of them for this purpose? Yes, I have managed to relay thru gmail. It was a bit hard to set up - build Postfix with SASL, sniff the traffic to figure out who signed gmail's SSL cert (Thawte), download CA cert - but I know how to do it. ;-) The downside is, the gmail relay rewrites the headers in annoying ways, so I'm not using it in general. If necessary I could relay just the "build breakage" thru them. Actually my incoming nimblemachines.com mail gets sent from my dynamic IP thru normal (non-AUTH, non-SSL) SMTP to gmail, and they accept it fine. So if I can send the build results to a gmail account, there are no problems. Hmm - and that account could forward to the git list... - David -- If I have not seen farther, it is because I have stood in the footsteps of giants.