From: James Le Cuirot Date: Thu, 10 Sep 2026 10:20:14 GMT Subject: [PATCH v3] rust: respect CARGO_BUILD_TARGET when locating build output Message-ID: <20260910102013.1235066-2-chewi@gentoo.org> In-Reply-To: When cross-compiling, Cargo always writes to a target-tuple subdirectory determined by CARGO_BUILD_TARGET, even when it matches the native tuple. The build looked in $BUILD_DIR/$BUILD_TYPE directly, so it failed to locate the freshly built library. Respect CARGO_BUILD_TARGET in the output path so the correct artifact is located. Signed-off-by: James Le Cuirot --- > This seems to be based on a bit stale codebase. Specifically you > would want to build on top of post-924dfced6b (Makefile: support > universal macOS builds via RUST_TARGETS, 2026-07-08) version of > Makefile. Apologies, I had used the maint branch. Now rebased on master. > When CARGO_BUILD_TARGET is not defined, this leaves double slashes > in the resulting pathname, which may not be incorrect per-se, but > still is not what you meant to say, which is probably a lot closer > to > > ${CARGO_BUILD_TARGET+$CARGO_BUILD_TARGET/} I believed this would not cause an issue, so I intentionally went with simplicity over correctness. It's not a big difference though, so this revision goes with correctness. Makefile | 2 +- src/cargo-meson.sh | 4 ++-- 2 files changed, 3 insertions(+), 3 deletions(-) diff --git a/Makefile b/Makefile index d4b7759..f0ca2e4 100644 --- a/Makefile +++ b/Makefile @@ -959,7 +959,7 @@ RUST_LIB_NAME = gitcore.lib else RUST_LIB_NAME = libgitcore.a endif -RUST_LIB = target/$(RUST_BUILD_CONFIG)/$(RUST_LIB_NAME) +RUST_LIB = target/$(if $(CARGO_BUILD_TARGET),$(CARGO_BUILD_TARGET)/)$(RUST_BUILD_CONFIG)/$(RUST_LIB_NAME) endif GITLIBS = common-main.o $(LIB_FILE) diff --git a/src/cargo-meson.sh b/src/cargo-meson.sh index 75f3cd1..83c7e7b 100755 --- a/src/cargo-meson.sh +++ b/src/cargo-meson.sh @@ -38,7 +38,7 @@ then exit $RET fi -if ! cmp "$BUILD_DIR/$BUILD_TYPE/$LIBNAME" "$BUILD_DIR/libgitcore.a" >/dev/null 2>&1 +if ! cmp "$BUILD_DIR/${CARGO_BUILD_TARGET:+$CARGO_BUILD_TARGET/}$BUILD_TYPE/$LIBNAME" "$BUILD_DIR/libgitcore.a" >/dev/null 2>&1 then - cp "$BUILD_DIR/$BUILD_TYPE/$LIBNAME" "$BUILD_DIR/libgitcore.a" + cp "$BUILD_DIR/${CARGO_BUILD_TARGET:+$CARGO_BUILD_TARGET/}$BUILD_TYPE/$LIBNAME" "$BUILD_DIR/libgitcore.a" fi -- 2.55.0